System Reports

The System Reports window allows you to select the reports the panel can send to the central station receiver. You can also enable keypad door access reports by device address and enable the panel Ambush code option. The options available in System Reports depend on the panel type and firmware version.

1. Go to Program > System Reports.

2. In Zone Restorals, select Yes to enable zone restoral reports, or No to disable zone restoral reports. To send zone restoral reports when a zone is disarmed, select Disarm.

3. In Open / Close Enable, select Yes to enable opening and closing reports. Select No to disable opening and closing reports.

4. In Access Keypad Enable, enter the keypad addresses that you want to include in access reports.

5. To send specific reports to the receiver, select the following reports as needed:

   • Abort Reports: Sent any time an area is disarmed after an alarm report has been sent and the bell cutoff time has not expired

   • Bypass Reports: Sends all zone bypasses, resets, and force arm reports to the receiver

   • Schedule Change Reports: Sends all schedule changes to the receiver

   • Code Change Reports: Sends all code additions, changes, and deletions to the receiver

   • Ambush Reports: Sends an ambush report to the central station whenever user code number one is entered at a keypad

   • Send Stored Messages: If a panel loses communication with the receiver, it will store any messages that are not able to be sent while communication was down.

   • Entry Check-In Protection: Enables the panel to send a check-in message when an Entry Delay begins.

6. In Late To Open, enter the number of minutes that the system can be disarmed after the scheduled opening time before a Late to Open message sent. Range is 0-240 minutes

7. In Early To Close, enter the number of minutes that the system can be armed before the scheduled closing time. Range is 0-240 minutes

8. Select OK.