Remote Options

The Remote Options window allows you to enter the information needed for connecting to the panel with Remote Link, Dealer Admin, Tech APP, and Virtual Keypad.

1. Go to Program > Remote Options > Standard.

2. In Remote Key, enter the remote key programmed in the panel. The remote key is required for connection to Remote Link.

3. To allow users to disarm the system from Virtual Keypad, select Remote Disarm.

4. In the Dialer, Network, Cellular, and RS232 sections, configure settings as needed for the panel connection type. For field descriptions, refer to "Standard Fields Reference".

5. To allow users to connect to the panel with Virtual Keypad, enter your app key in App Key.

6. In Send Local Changes, select one of the following options:

   • None: Does not allow the panel to automatically update remote programming workstations.

   • NET: Allows the panel to update remote programming workstations over network.

   • DD: Allows the panel to update remote programming workstations over dialer.

7. In Remote Change IP, enter the IP address for the workstation to send changes for NET.

8. In Remote Change Port, enter the port for the workstation to send changes for NET.

9. In Remote Phone Number, enter the phone number to send changes to for DD.

10. Select OK.

Standard Fields Reference

Dialer

• Armed Answer Rings: Enter the number of times to allow the phone line to ring before it answers when all areas of the system are armed. Range is 0-15. Default is 8. If 0 (zero) is entered, the panel does not answer the phone when all system areas are armed.

• Disarmed Answer Rings: Enter the number of times to allow the phone line to ring before it answers when any areas of the system are disarmed. Range is 0-15. Default is 8. If 0 (zero) is entered, the panel does not answer the phone when any system areas are disarmed.

• PC Modem: Allows panel dialer connection for remote programming at 2400 baud. Enable this option to allow communication through an SCS-105.

• Alarm Receiver: Select Yes to enable the panel to accept remote commands and programming from the alarm receiver. If you select No, the panel will not accept remote commands and programming from the alarm receiver.

• Service Receiver: Select Yes to enable the panel to accept remote commands and programming from a secondary service receiver other than the alarm receiver. This option must be Yes to allow programming from a directly connected computer using Remote Link. If you select No, the panel will not accept remote commands and programming from a secondary service receiver.

Network

• Allow Network Remote: Allow remote programming over network connection.

• Encrypt Network Remote: Encrypt data sent over network.

• Network Programming Port: Enter the panel port. Default is 2001.

Cellular

• Allow Cell Remote: Allow remote programming over cellular connection.

• Encrypt Cell Remote: Encrypt data sent over cell.

• First GPRS APN: Enter the first APN (Access Point Name). This allows an access point for cellular communication and is used to connect to a DNS network. Default is SECURECOM400.

RS232

• Allow RS-232 Remote: Enable to allow remote programming over the onboard RS-232 port. Default is enabled.