Network Options

To program network options, go to Program > Network Options. After configuring relevant settings, select OK.

Configure Options

1. To enable DHCP, select DHCP. To enter network options manually, clear DHCP. When using a hardwired connection on XR panels, users can program the specific DNS the panel should use even when DHCP is enabled.

2. In Local IP Address. enter the local IP of the panel with periods. The default is 192.168.0.250.

3. In Gateway Address, enter the panel gateway address with periods. The default is 192.168.0.1.

4. In Subnet Mask, enter the panel subnet mask with periods. The default is 255.255.255.0.

5. In DNS Server, enter the address of the DNS (Domain Name System) used by the panel to resolve domain names into IP addresses. The default is 192.168.0.1.

6. In Passphrase, enter the passphrase for encrypted network communication with the receiver. If you leave the Passphrase blank, the panel communicates with the receiver, but the data is not encrypted. The valid range is 8-16 alphanumeric characters. The default is blank. Do not lose the passphrase. A lost or forgotten passphrase requires that the panel and every line card at the receiver be individually reprogrammed with a new passphrase.

7. In 734N Listen Port, enter the port number that the 734N/734N-POE uses to send communication to the panel. Ensure this is the same port that is programmed in Panel IP Port within the 734N/734N-POE Communication programming menu. The 734N Listen Port cannot be the same as the panel network programming port.

8. In 734N Passphrase, enter a passphrase to encrypt communication with the734N/734N-POE module. Ensure the passphrase matches the one in communication programming of the 734N. The valid range is 8-16 alphanumeric characters. The default is blank. A passphrase is required for operation.

9. Enable XR/X1 Communication Communication: Select Yes to enable XR to XR communication. Select No to leave this option disabled.

10. DDP Passphrase: This option only displays if XR/X1 Communication is set to Yes. Enter a passphrase to encrypt XR to XR communication. The valid range is 8-16 characters.

Configure Wi-Fi Settings (Wi-Fi only)

1. In SSID, enter the name of the wireless network.

2. In Security, select WEP, WPA, or None. When possible, use WPA for wireless communication.

3. In Passphrase, enter the network password.

Enable IPv6

To enable IPv6, select DHCP, then select IPv6. IPv6 information is automatically populated when connected to a panel.