Modules Tab

The Modules tab allows you to configure settings for add-on modules.

Configure Monitoring Options

To access the Modules tab, go to System > Configure > Remote Link > Modules. After configuring the tab, select OK to save your settings.

Note: The following options are only visible if additional modules are installed

Host Monitoring

• Host Monitoring: To allow the module to receive signals from network enabled panels, select Host Monitoring Enabled.

• UDP Port: Enter the data network UDP port number through which the module will use to monitor for incoming alarm signals. 2001 is the default port.

Direct Monitoring

• COM Port: Select the COM port that is connected to your panel.

• Baud Rate: Set the baud rate to 9600.

Command Center

• Track Armed Status: Select Track Armed Status to allow the Command Center to display the armed/ disarmed status of all monitored accounts.